Dispensing Instructions

Step 1

Open the Beer Barista. Wet the dispenser line with water and insert into the hole behind the tap - barb up. 

 

Step 2

Push/wriggle the tube end into the tap, opening the tap as you do so, until the barb rests on the hole. You’ll see the tube peeking below the tap.  
 

Step 3

Double the beer line over and pinch flat, to block pressure. Stretch the flattened tubes into the V-slot, and push to base of the V-slot.  

 

Step 4

The beer line is now sealed off - ready for switching to pour.  
 

Step 5

Disconnect the beer line from the PRV barb (top left), by pulling the locking sleeve off and removing the tube. Then using clean scissors and a straight cut, trim 10mm off the brew line (to ensure a good new seal on the dispenser). 
 

Step 6

Connect that to the dispenser line barb and slide on the locking sleeve, as before. 

 

Step 7 

Release the brewing line, from the V-slot. 
 

Step 8

Coil the brewing line around the brew cap and close the machine lid.  
 

Step 9

Follow the instructions on the Beer Barista screen, selecting dispense mode. 
 

Step 10

Now you are ready to pour! Gently pull down on the tap. Note: It may take a moment for the beer to come through the line. Enjoy!